20241030-1246
- add support for Singapore region

20240906-1111
- increase GPS reception performance/quicker fix, by optimizing Bluetooth transmissions when the DroneBeacon has not a GPX fix.
- use hardware functions to generate random MAC address used in Bluetooth/WLAN transmissions.
- bug fix: disable RemoteID transmission when the module is in configuration mode

20240805-1119
- improved AUTO baudrate if the flight controller changes baudrates. For some flight controllers adjusting to the new baud rate was too slow

20240703-1654
- support for db152fpv and db153fpv modules
- allow baud rate changes by flight controller if set to AUTO baudrate.

20240501-1330
- bug fix use current time in the system message and not the take-off time
- prevent non-compliant settings for the USA region: only allow Bluetooth dual-mode and WLAN Beacon in the configuration menu. 

20240208-1759
- added support for u-blox UBX protocol
- added auto baud function to detect automatically the baud rate.
- added a secondary ID that will be included in the Remote ID signal. This is needed in the EU (for business clients).
- added a button 'to factory defaults' to set all parameters to default values
- improved description/explanation for the EU operator ID (OPRN) input box
- added extra regulatory checks for the EU: BLE legacy is an optional mode (not mandatory) and for WLAN modes an SSID is required. This only changes behavior if non-default radio parameters have been used.

20231104-1445
- bug fix: remove extra \n in GPS output stream
- bug fix: broadcast location data even if there is no GPS fix. Formally this is required by the Remote ID standards
- bug fix: better random MAC address generation. When the DroneBeacon device gets powered up, it will generate a random MAC address (hardware ID that is included in the Bluetooth/WLAN signals). In this version, better random MAC address generation is used. This should prevent that multiple DroneBeacon devices use the same MAC address. In such cases says 5% of DroneBeacon devices had the same random MAC address when previous firmware versions were used.
- bug fix: transmission rate. In previous versions, the data update rate was a bit too slow. Both the transmission interval and the number of transmissions have been optimized according to the Remote ID standards.
- added an option in the configuration pages (radio section) to disable broadcasting the DroneBeacon name. Normally it will broadcast 'DroneBeacon_' and the last 4 characters of the serial number as BLE device name and as SSID (if those broadcast methods are enabled).

20230609-1400
- if WLAN broadcast is used, other 2.4 GHz WLAN channels are also allowed (and are compliant).
- add option to enable (default) to disable responding to active WLAN scanning requests. If disabled, it will be much harder to be detected by smartphones

20230414-1334
- first public release