20240116-1645
- added a secondary ID that will be included in the Remote ID signal. This is needed in the EU (for business clients).

20240106-1158
- added a button 'to factory defaults' to set all parameters to default values
- improved description/explanation for the EU operator ID (OPRN) input box
- added extra regulatory checks for the EU: BLE legacy is an optional mode (not mandatory) and for WLAN modes an SSID is required. This only changes behavior if non-default radio parameters have been used.

20231023-1718
- bug fix: broadcast location data even if there is no GPS fix. Formally this is required by the Remote ID standards
- bug fix: better random MAC address generation. When the DroneBeacon device gets powered up, it will generate a random MAC address (hardware ID that is included in the Bluetooth/WLAN signals). In this version, better random MAC address generation is used. This should prevent that multiple DroneBeacon devices use the same MAC address. In such cases says 5% of DroneBeacon devices had the same random MAC address when previous firmware versions were used.
- bug fix: transmission rate. In previous versions, the data update rate was a bit too slow. Both the transmission interval and the number of transmissions have been optimized according to the Remote ID standards.
- added an option in the configuration pages (radio section) to disable broadcasting the DroneBeacon name. Normally it will broadcast 'DroneBeacon_' and the last 4 characters of the serial number as BLE device name and as SSID (if those broadcast methods are enabled).

20230609-1341
- if WLAN broadcast is used, other 2.4 GHz WLAN channels are also allowed (and are compliant).
- add option to enable (default) to disable responding to active WLAN scanning requests. If disabled, it will be much harder to be detected by smartphones

20230509-1209
- dropped GPS requirement of receiving at least 7 satellites introduced in 20230411-1543.

20230411-1543
- bug fix GPS lag up to 10 seconds (introduced in firmware 20230213-1330)
- improved web interface, also useable with mobile devices
- improved checking of EU rules
- slow blinking if non-compliant mode is selected
- select WLAN transmission channel (advanced)

20230213-1330
- bug fix, could not enter operator ID in webinterface
- move to new buld tools
- disable transmission in the dronebeacon is in config mode
- bug fix, force battery leds to be on in config mode

20230125-1715
- firmware for db100, db120 and db121 transponders
- bug fix sometimes the system time was incorrect when there is weak GPS reception

20221205-1525
- added support for db120 transponder
- add transmit power setting in webinterface
- set Remote ID classification based on selected region

20220923-1330
- added more functionality to the LED status in conformance with the FAA DoC requirements. LED status only flashes (status OK) if there is a GPS fix, a valid transmission mode is selected (configured region USA) and the internal tests do no show any error
- bug fix in some rare case it was possible to change the SN number, if a cached version of the web interface was used.

20220907-1556
- more F3586−22 updates

20220822-1603
- send static messages with 1 Hz update rate (in order to be compliant with F3586−22)

20220818-1402
- bug fix GPS latitude longitude issues in case the transponder is in the West and/or South quadrant.
- bug fix ASTM compliance NAN BSS ID (upgraded from v1.0 to 1.1 behaviour)
- bug fix WiFi beacon rate, set to the selected update rate
- bug fix WiFi NAN set the correct beacon interval parameter
 
20220720-1039
- first public release